# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
%YAML 1.2
---
$id: http://devicetree.org/schemas/gpio/spacemit,k1-gpio.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: SpacemiT K1 GPIO controller

maintainers:
  - Yixun Lan <dlan@gentoo.org>

description:
  The controller's registers are organized as sets of eight 32-bit
  registers with each set of port controlling 32 pins.  A single
  interrupt line is shared for all of the pins by the controller.

properties:
  $nodename:
    pattern: "^gpio@[0-9a-f]+$"

  compatible:
    const: spacemit,k1-gpio

  reg:
    maxItems: 1

  clocks:
    items:
      - description: GPIO Core Clock
      - description: GPIO Bus Clock

  clock-names:
    items:
      - const: core
      - const: bus

  resets:
    maxItems: 1

  gpio-controller: true

  "#gpio-cells":
    const: 3
    description:
      The first two cells are the GPIO bank index and offset inside the bank,
      the third cell should specify GPIO flag.

  gpio-ranges: true

  interrupts:
    maxItems: 1

  interrupt-controller: true

  "#interrupt-cells":
    const: 3
    description:
      The first two cells are the GPIO bank index and offset inside the bank,
      the third cell should specify interrupt flag. The controller does not
      support level interrupts, so flags of IRQ_TYPE_LEVEL_HIGH,
      IRQ_TYPE_LEVEL_LOW should not be used.
      Refer <dt-bindings/interrupt-controller/irq.h> for valid flags.

required:
  - compatible
  - reg
  - clocks
  - clock-names
  - gpio-controller
  - "#gpio-cells"
  - interrupts
  - interrupt-controller
  - "#interrupt-cells"
  - gpio-ranges

additionalProperties: false

examples:
  - |
    gpio@d4019000 {
      compatible = "spacemit,k1-gpio";
      reg = <0xd4019000 0x800>;
      clocks =<&ccu 9>, <&ccu 61>;
      clock-names = "core", "bus";
      gpio-controller;
      #gpio-cells = <3>;
      interrupts = <58>;
      interrupt-controller;
      interrupt-parent = <&plic>;
      #interrupt-cells = <3>;
      gpio-ranges = <&pinctrl 0 0 0 32>,
                    <&pinctrl 1 0 32 32>,
                    <&pinctrl 2 0 64 32>,
                    <&pinctrl 3 0 96 32>;
    };
...
